Small parts that make a SurRon Light Bee X easier to live with. Keep mud off the rider and the drive belt with the extended rear fender and belt guard, dress the cockpit with grips, ODI bar end plugs and an ODI number plate, and add handlebar switches for lights or extra circuits. For a bigger battery there is a lid lifting kit and an air cushion that stops the pack rattling.
Showing all 15 results
Protection for the bike
- Extended rear fender: polycarbonate, bolts under the seat into the original mounting points and holds back mud and water.
- Light Bee X belt guard: shields the main drive belt from dust, dirt and sand thrown up by the rear wheel.
- Battery bay: the lid lifting kit makes room for taller packs, and the air cushion holds the battery firmly in the frame.
Cockpit and controls
- 22.2 mm grips slide onto the standard Light Bee bar, and ODI alloy bar end plugs lock inside the bar ends.
- ODI Downhill number plate: a flexible race plate that straps to the fork tubes with cable ties, so nothing is drilled.
- Handlebar switches: a 3-position switch for headlight low and high beam, and 2-position switches, a push button with a rubber boot or a plain ON and OFF switch.
- FabiRide handlebar phone mount: holds phones 5.5 to 10 cm wide, upright or sideways.
Fitting tips
The switches are rated for DC circuits up to 100V and 8A, which makes them right for lights and control inputs, not for the main battery line. Not sure where a switch should go? Send a photo of your handlebar wiring to info@fabiride.com and we will tell you. The fender bolts on in a few minutes, and the ODI plate comes off between rides just as quickly. Changed your mind? A Light Bee X accessory that is unused and still sealed can come back to us within 14 calendar days.
Frequently asked questions
Does the extended rear fender need drilling?
No. It bolts under the seat into the original mounting points of the Light Bee, without adapters, and fitting takes a few minutes.
What can I wire to the handlebar switches?
They suit DC circuits up to 100V and 8A. Riders use them for headlights, a controller enable input or other low current circuits. They are not made for the main battery current.
Is the ODI number plate a registration plate?
No. It is a race and styling plate that mounts to the fork tubes with cable ties and also tidies the cables at the front. It does not replace a registration plate where one is required.
Will the 22.2 mm grips fit my Light Bee X?
Yes. They are made for the Light Bee L1e and X with a standard 22.2 mm (7/8 inch) bar, and they also fit the Talaria Sting and 3X.
Which phones fit the handlebar phone mount?
Phones from 5.5 to 10 cm wide, with or without a case. The mount turns for vertical or horizontal use, so navigation and music stay in view.
