The Talaria Sting throttle grip is an original OEM accelerator built for Talaria XXX, Talaria MX4 and Talaria MX5 electric off-road motorcycles. It uses a Hall-effect sensor instead of a mechanical cable. This twist throttle replaces a worn or damaged factory grip with an exact OEM match.
The grip features a round green OEM connector. It mounts on the right side of a Ø 22.2 mm (7/8″) handlebar. A standard 3-wire pinout — 5V, GND and Signal — sends the signal straight to the Talaria controller. This design ensures precise power dosing and a stable sensor response in every gear.
Because the connector is original, the throttle plugs into the Talaria wiring harness directly. No soldering or extra adapters are needed. The housing is built to handle vibration and rough off-road riding conditions.
Key Benefits
- OEM fit: matches the Talaria harness and controller exactly.
- Smooth acceleration: the Hall sensor gives stable, consistent throttle response.
- Fast installation: the round green connector plugs in without soldering.
- Off-road durability: the grip resists vibration and rough terrain.
- Precise power delivery: a steady signal improves control on difficult surfaces.
- Clean wiring: the original connector keeps the harness tidy, with no extra adapters.
Who Is This For
This throttle grip suits owners of the Talaria XXX, Talaria MX4 and Talaria MX5. It is designed for riders replacing a worn or damaged factory throttle. The grip fits the right side of a Ø 22.2 mm (7/8″) handlebar only.
It works for daily riding and for off-road use where precise power control matters. It also suits riders who prefer a genuine OEM part over a universal aftermarket throttle (twist throttle).
Technical Specifications
| Type | Twist throttle / accelerator (Hall-effect sensor) |
|---|---|
| Compatible models | Talaria XXX, Talaria MX4, Talaria MX5 |
| Connector | Round green (OEM Talaria) |
| Handlebar diameter | Ø 22.2 mm (7/8″), right side |
| Wiring | 3-wire signal — 5V / GND / Signal (OEM pinout) |
| Installation | Plug-and-play into the Talaria harness |
| Package contents | Throttle grip only, no extra accessories |
Why Choose the Talaria Sting Throttle Grip
The original OEM connector matches the Talaria harness pinout exactly. This removes the risk of wiring the connections incorrectly. The Hall sensor also has no mechanical wear point, so the signal stays stable longer than cable-driven throttles.
This grip fits exactly three models — Talaria XXX, MX4 and MX5. No adapters or handlebar modifications are needed for these models.
FAQ
Does this throttle grip fit the Talaria XXX?
- Yes. The round green OEM connector is compatible with the Talaria XXX.
Does it fit the Talaria MX4 and MX5?
- Yes. This grip works with both the Talaria MX4 and the Talaria MX5.
Can I install it on the left side of the handlebar?
- No. This throttle grip is built only for the right side.
Will it work with an aftermarket controller?
- Yes, if the controller uses the same 5V / GND / Signal pinout.
- Always check the controller’s wiring diagram before installing.
Do I need to calibrate the throttle after installation?
- Calibration is usually not required.
- Some controllers let you adjust the throttle curve in software.
What handlebar diameter does it require?
- The grip fits a Ø 22.2 mm (7/8″) handlebar.
Is soldering needed for installation?
- No. The round green OEM connector plugs directly into the harness.
The Talaria Sting throttle grip is a genuine OEM part for a fast, accurate throttle upgrade on the Talaria XXX, MX4 and MX5.
There are no reviews yet.