Higo 8pin → 1T4 extension connector (IP65, 2 A)

The Higo 8pin – 1T4 extension cable splits the single 8-pin main connector – handy for neatly connecting a display, brake sensors, accelerator, PAS/lights or other accessories when more reach is needed in the frame or steering area. IP65 protection and up to 2 A current for signal circuits.

Key features

• Plug & Play in the Higo ecosystem – without soldering
• IP65 – resistant to dust and water splashes
• Max. Current: up to 2 A (for signals and small loads)
• Flexible, durable insulation for use on handlebars and inside the frame

Specifications

• Type: Higo 8-pin → 1T4 extension
• Max. Current: 2 A
• Resistance: IP65
• Colour: black

Installation

1. Switch off the power and disconnect the battery.
2. Connect the 8-pin plug to the main wiring harness.
3. Check that the cables do not get caught in the fork travel and steering rotation.

FAQ

Is it suitable for any Higo 8-pin wiring harness?
Yes, if a standard Higo 8-pin pinout is used.

Can I power the lights through this cable?
Yes, as long as the current does not exceed 2 A and it meets the specifications of your controller.

Is it safe to install outside?
IP65 protects against dust and splashes, but avoid high-pressure washing directly into the connectors.

Higo 8pin 1T4, Higo extension, e-bike wiring harness, speed/brake/throttle connector, Higo splitter, IP65 2A, FabiRide