ASI BAC wires Talaria Sting

Plug & Play wiring harness for Talaria Sting motorcycle, for ASI BAC4000 and ASI BAC8000 controllers. Compatible with APT 750C and Eggrider V2 displays. Includes encoder → HALL signal converter to make ASI controllers work seamlessly with Talaria OEM systems.

Key benefits

• Quick installation: OEM lengths, without soldering.
• Full compatibility with BAC4000 / BAC8000, APT 750C, Eggrider V2.
• Signal converter included: the encoder converts signals to HALL – stable start and low cogging.
• Reliability: low impedance, high quality contacts, reverse polarisation protection (mechanical key).

Compatibility

• Motorcycle: the Talaria Sting (MX3 / MX4).
• Controls: ASI BAC4000, ASI BAC8000.
• Displays: APT 750C, Eggrider V2

What’s included

• 1× harness Talaria → ASI BAC
• 1× encoder → HALL signal converter (for Talaria sensors)

Installation

1. Disconnect the battery, remove the OEM controller.
2. Connect the cable to the ASI BAC and Talaria connectors (keyed fiche).
3. Insert the encoder→HALL module between the motor sensor and the controller.
4. Install the screen (APT 750C or Eggrider V2), arrange cable routing.
5. Switch on the system, perform a basic check of the BAC parameters (rim diameter, poles, direction).

FAQ

Does it work with the OEM Talaria motor?
Yes, with the encoder→HALL converter included, it works with OEM sensors.

Is additional programming necessary?
It is recommended to check the BAC parameters (poles, direction, limiters).

Will it work with other displays?
APT 750C with the correct protocol and Eggrider V2 are officially supported; compatibility with other displays may vary.

ASI BAC harness Talaria, BAC4000 harness, BAC8000 harness, Talaria Sting ASI, Eggrider V2 APT 750C, encoder to hall converter, FabiRide harness